HFL200SA-xx

• Reliable LED floodlight, low cost of ownership
• Low power consumption due to highly efficient LED lights source and lens system
• Double entry for looping purposes to other floodlights
• Low profile design (<150 mm) allows direct mounting on helideck
• Offshore resistant, high quality coating on cast light alloy base
• Stainless steel (SS316) mounting facilities to prevent corrosion problems
• Wide beam spread for optimised and even helideck illumination

Electrical characteristics

• Operating voltage: see table
• Power consumption: see table
• Connection details: M4; two M20x1,5 cable gland entries
• Earth connection: internal M4 and external M5

• Complies with ICAO Annex 14, Volume ll; International standards and recommended practices: Aerodromes, July 2013, chapter 5, paragraph 5.3.9 – Helideck Floodlights*
• Complies with Norway – BSL D 5-1 – Regulations relating to helicopter aviation – use of offshore helidecks, Section 36
• Complies with USA – HSAC RP 161 – New Build Helideck Design Guidelines, Section 7.3
• Complies with CAA-UK CAP 437 9^th edition; general maintenance flood lighting, Chapter 4, § 4.23 & 4.24.
• Complies with Brazil – NORMAM-223/DPC – Maritime Authority Standards for Registration Of Helidecks, Section 5.5
• Complies with UAE – CAAP 71 – Helidecks (off-shore) – Chapter 13, Section 2

Physical characteristics

• Dimensions (L x W x H): 256 x 278 x 147 mm
• Weight: 8 kg
• Degree of protection: IP66
• Operating temperature range: -25°C to +55°C

• Steady burning; white
• Highly efficient LED light source and lens system
• No glare

SYSTEM DESIGN, CONTROL AND MONITORING

• *) When used in a floodlight system, based on advised number of lights at defined positions, the average horizontal illuminance of the floodlighting will meet the regulatory requirements of at least 10 lux, with a uniformity ratio (average to minimum) of not more than 8:1 measured on the surface of the TLOF.